Clone stack invisibly

[xbury.cs at clearstream.com]

Just make the stack not visible before cloning it.

Tested in the Script Editor installer... For a later release! ;)


---------------------=---------------------
Xavier Bury
TNS NT LAN Server
ext 6465




"J. Landman Gay" <jacque at hyperactivesw.com>
Sent by: metacard-admin at lists.runrev.com
10/09/03 06:39
Please respond to metacard

 
        To:     metacard list <metacard at lists.runrev.com>
        cc:     ^
        Subject:        Clone stack invisibly



Is there syntax to clone a stack invisibly? I'm looking for a way to set 
the title of a newly cloned stack without seeing the old title flash by 
first.

-- 
Jacqueline Landman Gay         |     jacque at hyperactivesw.com
HyperActive Software           |     http://www.hyperactivesw.com


_______________________________________________
metacard mailing list
metacard at lists.runrev.com
http://lists.runrev.com/mailman/listinfo/metacard





Visit us at http://www.clearstream.com
                                                          
IMPORTANT MESSAGE

Internet communications are not secure and therefore Clearstream International does not accept legal responsibility for the contents of this message.

The information contained in this e-mail is confidential and may be legally privileged. It is intended solely for the addressee. If you are not the intended recipient, any disclosure, copying, distribution or any action taken or omitted to be taken in reliance on it, is prohibited and may be unlawful. Any views expressed in this e-mail are those of the individual sender, except where the sender specifically states them to be the views of Clearstream International or of any of its affiliates or subsidiaries.

END OF DISCLAIMER